Menu

Connect with us

Thermal protector / temperature control switch, KSD9700250v5a rubber shell thermostat

Heat protector / temperature control switch KSD970050 degree 55 degrees, 60 degrees, 65 degrees, 70 degrees, 80 degrees, 85 degrees, 90 degrees, 95 degrees, 100 degrees, 75 degrees, 105 degrees, 110 degrees

price:USD$0.80
discount 70% in 2018-09-24 to 2018-09-26
price: USD$ 0.56
freight :USD$18.00,(Express)
freight :USD$7.00,(Postal parcel)
Minimum Order Quantity:16
views:0
Search Similar or mail to saler or send message to saler

Pay with PayPal, PayPal Credit or any major credit card

 

 

KSD9700 is a closed type thermostat thermostat Japan Sumitomo BR-1 thermal bimetal development, with quick, accurate temperature control, control current, long service life, is widely used in various types of micro motor, electromagnetic oven, air conditioner motor, small appliances such as temperature control protection.
The elastic element with environment-friendly silver contacts connected to the bottom plate, the bottom plate and the spring piece is arranged to sense the temperature of the spirit of double metal disc, embedded shell, bimetal heat to achieve the required, double sheet metal when the value of the instant action, this circuit is cut off, when the temperature drops to complex temperature, double metal and quickly closed circuit switched on again.
Application in overheat protection:
1, all kinds of motor / micro motor 2, induction cooker 3, ballast 4, electric belt 5, health care equipment
 
6, electric heating appliance 7, water pump 8, exhaust fan 9, vacuum cleaner 10, power tools 11 battery 12, a variety of electric heating products and so on.
 
 
According to the nature of action, it can be divided into normally open action and normally closed action.
Matters needing attention
1, the use of contact temperature installation, should make the product attached to the surface of the charged device.
2, the installation can not put the plastic or metal casing collapse or deform, so as not to affect the performance of.
3, metal products with insulating sleeve in the installation can not be removed or crushed without external insulation sleeve, to avoid leakage, to ensure safe use.
4, the products are used in the circuit is not greater than the 5A current, should choose the copper core section is connected with the wire 2 mm 0.4-0.75.
5. The products should be stored in the places where the relative humidity is less than 90%, the ambient temperature is below 40 degrees, and the places are ventilated, clean, dry and non corrosive gas.