Menu

Connect with us

High grade controller / electric geothermal UTH-200 Korea imported / floor heating thermostat / temperature control switch / film temperature

price:USD$236.00
discount 70% in 2018-10-18 to 2018-10-20
price: USD$ 165.20
freight :USD$18.00,(Express)
freight :USD$7.00,(Postal parcel)
views:0
Search Similar or mail to saler or send message to saler

Pay with PayPal, PayPal Credit or any major credit card

527053659360

Baby delivery: Shandong, Qingdao

 

Product Name:Temperature controller -UTH-200 for electric heating film

Purpose: electric control heating, electrothermal film, electric heating plate, steam room, yoga room and other heating device temperature.

Voltage:220V50HZ

Power:4KW

Rated input voltage:85V AC ~ 265V AC

Output voltage:85V AC ~ 265V AC

Maximum capacity:18A (impedance load)

Temperature range:0 - 60(℃)

Features: simple operation, to set the temperature after the whole braking, power off starting constant temperature system.

Friendship tipsA single temperature controller can control the maximum of no more than 15 square meters of electric heating film. The power of the electric heating film should not exceed 80 of the rated power of the thermostat%

 

BAR displayWhen the regulator works, the switch in the direction of the heater indicates the state of ON or OFF.
When the BAR switch is in the state of OFF, (as shown in Fig.), the "OFF" is displayed, and the BAR work at the lower end is also stopped. "ON" is displayed when the switch is in ON state, and the BAR at the lower end continues to work.


Temperature displayWhen the basic sensor mode works, the temperature display window shows the current temperature. No other operation is to show the current temperature, the operation temperature setting button (up or down) to display the set temperature. At the beginning of the first job, display the setting temperature, and then set the temperature to increase or decrease.

Basic movements
POWERKEY switch ON/OFF power supply, OFF other key or regulator does not work.

The key moment or so long, the lower part of the BAR chart display disappears and the set temperature is. After setting the required temperature, there is no operation in 3 seconds, and the temperature and the lower end of the BAR chart are re displayed. Because buttons are touching, they begin to work with their fingers gently touching, noting that they do not work with other objects,.
Touch the power button ON, 2 times the subwoofer, OFF hair 1 times, so it is easy to distinguish. When touching the button, be careful not to touch with other keyboards simultaneously.


Initialization function

This is the function of restoring factory settings. When the installation is wrong or the noise regulator work is wrong, all the setting range and the setting temperature state are restored to the original factory function.
The method of work is press and hold the power button for about 10 minutes after the wonderful, the temperature on the display window "SAU" flash three times all digital regulator also restored to the original value.
When setting the initial stage, the sensor mode settings and timer values are converted to the initial values and stored. )


Sensor mode

Compare the current temperature and the required temperature (set) switch ON/OFF, and control the way of work from the sensor.

Setting method

The basic working mode will be automatically set when the sensor is attached to the sensor by the sensor. Specific settings can be changed again.
At the same time we hold the button for 3 seconds, "Stn said, FUNCTION began to show.
On the state of the Stn representation, the pressed buttons are displayed in the order of SEn – tIn. In that the window has been set Sen, then we put at the same time, press a button ". In this way, the last 3 flashes of "SAU" are expressed and changed to the set value