It is applied to indoor public places that need to be protected, such as low ceilings, indoor stadiums, factory areas and parking lots.
The lamp shell is made of high strength steel plate, the surface electrostatic spray processing, powder adhesion strength, uniform and bright, the long-term use is not easy to peel off the shell welding, solder joints and splicing gap polishing, spray after do not see the gap defects; configuration of high purity anodized aluminum reflector, reasonable light distribution, create high brightness lighting environment, for some special occasions for illumination requirements; surface cover to door type steel arch wire, can effectively prevent the impacting of lamps and light sources.
The lamp holder and the connection terminal are all blockedPCMaterial, in line with3CStandard;
Wire resistance to high temperature90At high temperature, high pressure resistance300/500VAccord with3CStandard;
Configurable emergency system, dimming system.
accord withIECInternational safety standards,GB7000.1-2002National standard；
Suction ceiling installation can also be done by suspension system;
Unarmed directly remove the protective network, you can change the light source, line detection and maintenance;
Material: cold rolled steel plate, surface powder injection, powder injection material thickness is0.7
Light source: LEDProtection grade:IP65
Explosion proof grade:Ex IIC
This product is in strict accordance with the ISO9001:2008 international quality management system standards for quality control, ensure product quality is higher than the national standard, fully meet the design requirements, products three years warranty (1 light years). Within 3 years from the date of purchase, the product normally under the use of any fault, the company responsible for maintenance free.